Toyota
Ford Kuga
 Service Manual
Safety Belt System
Component Test

Poor Retraction

If a safety belt does not retract correctly, check that the anchor covers and trim bezels are correctly installed and not rubbing against the safety belt webbing. Where necessary, check that the safety belt webbing is not rubbing at one end of the retractor cover slot and, if so, correct by loosening the retaining bolt, aligning the retractor to centralize the safety belt webbing and retighten the bolt.

The safety belts are "dual sensitive" which means that they have:

  • a vehicle motion sensor, which locks the safety belt webbing under braking, cornering, on steep hills and in adverse camber conditions.
  • a webbing motion sensor, which locks when the safety belt webbing is quickly extracted.

Both systems should be fully operational and can be checked by the tests below:

    More about «Safety Belt System»:

    Principles of Operation

    Inspection and Verification

    Component Test

    Vehicle Motion Sensor Test

    Test Method 1 (braking)

    Test Method 2 (turning circle)

    Static Test

    Front Safety Belt Retractor

    Rear Safety Belt Retractor

    Rear Center Safety Belt Retractor

    Safety Belt Shoulder Height Adjuster

    Front Safety Belt Buckle

    Ford Kuga Service Manual / Safety Belt System / Component Test

    Ford Kuga Service Manual

    Main Categories


    © 2017-2024 Copyright www.fokuman.com
    0.0068