Toyota
Ford Kuga
 Service Manual
Wipers and Washers » Wipers and Washers
Inspection and Checking

NOTE: The generic electronic module (GEM) forms part of the central junction box (CJB).

NOTE: If the generic electronic module (GEM) is changed, the new one must be reinitialized. For this purpose, the vehicle-specific data is read out of the module to be replaced using the Ford approved diagnostic tool and is transferred to the new module.

REFER to: Communications Network (418-00 Module Communications Network, Diagnosis and Testing).

NOTE: Before reading out the vehicle-specific data, remake all the electrical connections to the module to be removed, so that communication between the module and the Ford approved diagnostic tool is ensured.

1. Verify the customer concern.

2. Visually inspect for obvious signs of mechanical and electrical damage: NOTE: Ensure correct engagement of the wiring harness connectors.

Visual Inspection Char1:

Mechanical Electrical
  • Wiper blade(s)
  • Wiper arm shaft
  • Washer reservoir
  • Hose(s)
  • Nozzles
  • Check the passenger-side wiper blade for residue-free wiping in the vicinity of the rain sensor
  • Check the adhesive pad between the rain sensor and the windshield for trapped air.
  • Clean wax residues from the windshield in the vicinity of the rain sensor
  • Check the windshield for damage/cracks in the vicinity of the rain sensor.
  • Check that the rain sensor retaining frame is correctly attached to the windshield.
  • Fuse(s)
  • Connectors
  • Wiring harness
  • Washer pump motor
  • Headlamp cleaning system pump
  • Headlamp cleaning system relay
  • Front/rear window wiper motor
  • Wash/wipe system switch
  • Central junction box (CJB):
  • Battery junction box (BJB)

3. Resolve any obvious causes or concerns found during the visual inspection before carrying out any further tests.

4. If the concern persists after the visual inspection, PERFORM a fault diagnosis on the generic electronic module (GEM) using the Ford approved diagnostic tool and RESOLVE the fault(s) displayed according to the fault description. CHECK the operation of the system.

5. On a vehicle without stored fault(s), continue according to the Symptom Chart and the corresponding symptom.

6. After checking or rectifying the fault(s) and finishing the work, READ OUT the fault memory in the generic electronic module (GEM) and DELETE any saved faults. After performing a road test and CHECKING the system, READ OUT the fault memories again.

    More about «Wipers and Washers»:

    Description of operation

    Inspection and Checking

    Ford Kuga Service Manual / Wipers and Washers / Wipers and Washers / Inspection and Checking

    Ford Kuga Service Manual

    Main Categories


    © 2017-2024 Copyright www.fokuman.com
    0.0068