Toyota
Ford Kuga
 Service Manual
Engine System - General Information
Ultraviolet (UV) Testing

1. Clean the engine and transmission with a suitable cleaning fluid.

2. Pour the UV-test fluid in accordance with the quantity specified by the manufacturer through the oil filler neck into the engine and install the oil filler cap.

WARNING: Vehicles with manual transaxle, shift the transaxle into Neutral. Failure to follow this instruction may result in personal injury.

3. Start the engine and let it run for about five minutes.

4. Switch off the engine.

NOTE: If no leak can be found, road test the vehicle under various loads and check the engine for leaks again.

5. Check the engine for oil leaks using a suitable UV lamp.

6. Rectify any leaks found and check the engine for oil leaks.

    More about «Engine System - General Information»:

    Engine - Oil Leaks

    Ultraviolet (UV) Testing

    Measure the compression pressure

    Measure the compression pressure (Engine - 2.5L Duratec-ST (VI5)

    Measure the compression pressure (Engine - 2.0L Duratorq-TDCi (DW) Diesel)

    Measure the oil pressure (Engine - 2.5L Duratec-ST (VI5)

    Measure the oil pressure (Engine - 2.0L Duratorq-TDCi (DW) Diesel)

    Ford Kuga Service Manual / Engine System - General Information / Ultraviolet (UV) Testing

    Ford Kuga Service Manual

    Main Categories


    © 2017-2024 Copyright www.fokuman.com
    0.0084