Toyota
Ford Kuga
 Service Manual
Safety Belt System
Inspection and Verification

The ELR WMS is operated by rapid acceleration of the webbing. Once operated, it causes a locking pawl to be engaged thus locking the retractor.

Webbing payout is prevented in the same manner as VMS.

Inspection and Verification

1. Verify the customer concern.

2. Visually inspect for obvious signs of mechanical and electrical damage.

Visual Inspection Chart

Mechanical

  • Safety belt retractor
  • Safety belt buckle and pretensioner
  • Safety belt buckle

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

4. If the cause is not visually evident, verify the symptom and refer to the Symptom Chart.

Symptom Chart

Symptom Possible Sources Action
Normal mode - occupant restraint system inoperative Safety belt retractor. CARRY OUT the Safety Belt Component Test in this section
    More about «Safety Belt System»:

    Principles of Operation

    Inspection and Verification

    Component Test

    Vehicle Motion Sensor Test

    Test Method 1 (braking)

    Test Method 2 (turning circle)

    Static Test

    Front Safety Belt Retractor

    Rear Safety Belt Retractor

    Rear Center Safety Belt Retractor

    Safety Belt Shoulder Height Adjuster

    Front Safety Belt Buckle

    Ford Kuga Service Manual / Safety Belt System / Inspection and Verification

    Ford Kuga Service Manual

    Main Categories


    © 2017-2020 Copyright www.fokuman.com
    0.0126