Ford Kuga

 Service Manual

Fuel Tank and Lines
Fuel Tank Filler Pipe

General Equipment

Fluid Container

General Equipment

Fuel Tank Draining Equipment

Hose Clamp Remover/Installer

Removal

WARNING: Make sure that the fuel tank is no more than 3/4 full.

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the rear wheel on right-hand side.

Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

WARNING: Be prepared to collect escaping fluid.

CAUTION: Use suitable paper to absorb any escaping fluid.

General Equipment: Hose Clamp Remover/Installer

3. Torque: 10 Nm

WARNING: Fuel may still be present in the fuel tank after draining.

1. Make sure, that the fuel filler pipe is above the fuel level.

General Equipment: Hose Clamp Remover/Installer

2. Drain the reservoir.

General Equipment: Fuel Tank Draining Equipment

General Equipment: Fluid Container

Installation

1. To install, reverse the removal procedure.

2. NOTE: Make sure that a new component is installed.

1.

NOTE: Make sure that a new clamp is installed.

NOTE: Make sure that the clamp is installed to the same orientation as when removed.

General Equipment: Hose Clamp Remover/Installer 2. NOTE: Make sure that a new clamp is installed.

NOTE: Make sure that the clamp is installed to the same orientation as when removed.

General Equipment: Hose Clamp Remover/Installer

Fuel Tank and Lines - 2.5L Duratec (147kW/200PS) - VI5 (Component Location)

Fuel Tank and Lines - 2.5L Duratec (147kW/200PS) - VI5 (Overview)

Fuel Tank - 2.5L Duratec (147kW/200PS) - VI5

Fuel Level Sensor - 2.5L Duratec (147kW/200PS) - VI5

Fuel Tank Filler Pipe

Fuel Filler Nozzle Inhibitor

Fuel Pump and Sender Unit - 2.5L Duratec (147kW/200PS) - VI5