Toyota
Ford Kuga
 Service Manual
Hydraulic Brake Actuation
Brake Master Cylinder - 2.5L Duratec (147kW/200PS) - VI5

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Brake System Health and Safety Precautions (100-00 General Information, Description and Operation).

2. Connect one end of a suitable piece of clear plastic pipe to the brake caliper bleed nipple 1.

and place the other end into a suitable container.

2. Loosen the bleed nipple.

3. Depress the brake pedal until no more brake fluid comes through the bleed nipple.

4. Tighten the bleed nipple.

5. Repeat the draining procedure on the opposite side brake caliper.

Brake Master Cylinder - 2.5L Duratec (147kW/200PS) - VI5

Left-hand drive vehicles

CAUTION: Make sure that all openings are sealed.

1. Torque: 18 Nm

2. NOTE: Make sure that new components are installed.

Torque: 25 Nm

Brake Master Cylinder - 2.5L Duratec (147kW/200PS) - VI5

Right-hand drive vehicles

CAUTION: Make sure that all openings are sealed.

1. Torque: 18 Nm

2. NOTE: Make sure that new components are installed.

Torque: 25 Nm

Brake Master Cylinder - 2.5L Duratec (147kW/200PS) - VI5

Installation

1. To install, reverse the removal procedure.

2. Refer to: Brake System Bleeding (206-00 Brake System - General Information, General Procedures).

Refer to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures).

    More about «Hydraulic Brake Actuation»:

    Brake Pedal and Bracket - RHD 4WD/RHD FWD

    Brake Master Cylinder - 2.5L Duratec (147kW/200PS) - VI5

    Ford Kuga Service Manual / Hydraulic Brake Actuation / Brake Master Cylinder - 2.5L Duratec (147kW/200PS) - VI5

    Ford Kuga Service Manual

    Main Categories


    © 2017-2024 Copyright www.fokuman.com
    0.008