Paint - General Information » Refinishing Materials
HS primer filler and HS tinted filler
Note:
- Primer filler is available as 1-component and
2-component water based and solvent based
forms.
- 1-component products are only suitable for
isolation of sanded through bare areas and new
painting.
- Water based products are also used for the
skinning of thermoplastics and substrates which
are sensitive to solvents.
- Tinted fillers can be individually matched to the
top coat color and therefore find uses in effect
paints and paints with poor covering power.
- Use dry sand or wet sand filler according to
application in order to avoid unnecessary
sanding work.
- On critical substrates the use of epoxy resin
base filler is recommended in order to avoid
adhesion problems.
![HS primer filler and HS tinted filler](images/books/262/15/index.12.jpg)
![HS primer filler and HS tinted filler](images/books/262/15/index.13.jpg)
*ln order to avoid boiling out, drying should be
performed slowly.
Paint
The base and the clear lacquer must be matched
to one another.
![Paint](images/books/262/15/index.14.jpg)
The base paint must be dried matt before the clear
lacquer is applied.
![Paint](images/books/262/15/index.15.jpg)
![Paint](images/books/262/15/index.16.jpg)
More about «Refinishing Materials»:
HS primer filler and HS tinted filler