Ford Kuga

 Service Manual

Instrument Panel and Console
Instrument Panel

Removal

WARNINGS:

• The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected.

  Wait for a minimum of 3 minutes before disconnecting or removing any SRS components.

• Make sure that the vehicle electrical system is fully depowered and no other power source is connected.
• Wear safety goggles.

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions (100-00 General Information, Description and Operation).

2. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

3. Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).

4. Torque: 25 Nm

5. Remove the front doors.

7. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

8. Refer to: Climate Control Assembly - Vehicles With: Manual Temperature Control (412-01 Climate Control, Removal and Installation).

Refer to: Climate Control Assembly - Vehicles With: Automatic Temperature Control (412-01 Climate Control, Removal and Installation).

2008.50 Kuga

14. Refer to: Headlamp Switch (417-01 Exterior Lighting, Removal and Installation).

16. 1. Torque: 7 Nm

2. Torque: 9 Nm

17. Remove both sides.

Refer to: A-PillarTrim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

18. Torque: 28 Nm

19. On both sides Torque: 25 Nm

23. NOTE: Note the position of the component before removal.

On both sides

Torque: 25 Nm

24.1. Install M10 x 120 mm guide bolts in the right and left-hand A-pillar.

2. Torque: 80 Nm

Installation

1. To install, reverse the removal procedure.

Instrument Panel

Floor Console

Overhead Console

In-Vehicle Crossbeam