Toyota
Ford Kuga
 Service Manual
Anti-Lock Control - Stability Assist
Hydraulic Control Unit (HCU)

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Brake System Health and Safety Precautions (100-00 General Information, Description and Operation).

2. Refer to: Battery (414-01 Battery, Mounting and Cables, Removal and Installation).

3. Torque: 12 Nm

Hydraulic Control Unit (HCU)

4. Connect one end of a suitable piece of clear plastic pipe to the brake caliper bleed nipple 1.

and place the other end into a suitable container.

2. Loosen the bleed nipple.

3. Depress the brake pedal until all the brake fluid is drained from the brake fluid reservoir.

4. Tighten the bleed nipple.

5. Repeat the draining procedure on the opposite side brake caliper.

Hydraulic Control Unit (HCU)

Left-hand drive vehicles

5. NOTE: Make sure that the seal is correctly located.

Torque: 18 Nm

Hydraulic Control Unit (HCU)

Right-hand drive vehicles

Hydraulic Control Unit (HCU)

7. Torque: 18 Nm

Hydraulic Control Unit (HCU)

All vehicles

8. NOTE: Make sure that the seal is correctly located.

2. Torque: 18 Nm

3. Torque: 9 Nm

Hydraulic Control Unit (HCU)

9. Torque: 9 Nm

Hydraulic Control Unit (HCU)

10. Refer to: Stability Assist Module (206-09 Anti-Lock Control - Stability Assist, Removal and Installation).

Installation

CAUTION: If accidentally dropped or knocked install a new hydraulic control unit (HCU) and module.

The blanking caps/plugs must not be removed until the brake tubes are ready to be connected.

To install, reverse the removal procedure.

2. Refer to: Brake System Bleeding (206-00 Brake System - General Information, General Procedures).

Refer to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures).

    More about «Anti-Lock Control - Stability Assist»:

    Anti-Lock Control - Stability Assist (Overview)

    Anti-Lock Control - Stability Assist (System Operation and Component Description)

    Hydraulic Control Unit (HCU)

    Stability Assist Module

    Front Wheel Speed Sensor

    Rear Wheel Speed Sensor

    Yaw Rate Sensor

    Ford Kuga Service Manual / Anti-Lock Control - Stability Assist / Hydraulic Control Unit (HCU)

    Ford Kuga Service Manual

    Main Categories


    © 2017-2024 Copyright www.fokuman.com
    0.0087