Toyota
Ford Kuga
 Service Manual
Safety Belt System
Test Method 2 (turning circle)

This method requires a flat open area of private road, sufficient for the vehicle to be driven in a continuous circle on full steering lock.

  • The driver should wear the safety belt provided and the belt webbing must be correctly adjusted, with no slack.
  • The passenger should occupy a rear seat with the safety belt correctly adjusted, with no slack.
  • Start the engine and, with the steering on full right-hand lock, drive the vehicle in a continuous circle at 16 km/h (10 mph). Do not exceed 16 km/h (10 mph) for this test.
  • When the speed is stable, the passenger should attempt to slowly extract the safety belt webbing from each safety belt retractor in turn. If the vehicle motion sensitive lock mechanism is operating correctly, it will not be possible to extract the webbing.
  • Any safety belt retractor from which it is possible to extract the webbing during this test must not be used. A new safety belt must be installed.

    More about «Safety Belt System»:

    Principles of Operation

    Inspection and Verification

    Component Test

    Vehicle Motion Sensor Test

    Test Method 1 (braking)

    Test Method 2 (turning circle)

    Static Test

    Front Safety Belt Retractor

    Rear Safety Belt Retractor

    Rear Center Safety Belt Retractor

    Safety Belt Shoulder Height Adjuster

    Front Safety Belt Buckle

    Ford Kuga Service Manual / Safety Belt System / Test Method 2 (turning circle)

    Ford Kuga Service Manual

    Main Categories


    © 2017-2024 Copyright www.fokuman.com
    0.008